Moduleur ADSR + VCA

Envelope times reach about ten seconds depending on pot values, and the ADSR output can be normalled to the VCA control input. A bias trimmer sets the VCA base level. Check the module FIXLOG for PCB errata before building an older revision. Part of the Shmoergh Moduleur, a full DIY analog synth whose modules also work standalone in any Eurorack case. Split into a core PCB and a UI PCB; the core is mostly 0603 chip parts with JLCPCB gerbers and pick-and-place files, so the surface mount side can be fab assembled.

Documentation

• Assembly instructions
• Bill of materials (BOM)
• Schematic
• Fabrication files (PCBA-ready)

Links

• Source / files on GitHub
• Maker page

More from Shmoergh

Moduleur VCO Analog VCO with sub oscillator, noise, PWM and hard sync Moduleur Sidechain Mixer 4 channel DC coupled mixer with VCA sidechain compressor Moduleur VCF Dual mode analog multimode diode filter Moduleur Crush + LFO + Output Analog bitcrusher, LFO and line level output stage Moduleur Brain Raspberry Pi Pico digital module with MIDI, CV and pulse IO

More envelope modules

Stages Mutable Instruments Peaks Mutable Instruments ADSR diysynth Cycling Envelope Generator diysynth Looping A-R diysynth Sigma Voxmachina EG Super Synthesis ADSR CubuSynth

This is a third-party open-source design, listed here as a build reference. Specs are researched from public sources; check the source repo and store for the current BOM, panel, and revision before ordering parts. Corrections welcome.

← Back to all builds Resources Suggest a correction or a missing module