Dual Mixer

Maker	Jypma
Type	Two four channel mixers with buffered inputs and peak LEDs
Mounting	Mixed
Width	8 HP
License	Proprietary (No licence published)
Difficulty	🔥 SMD (0805)

Chip parts are 0603 rather than 0805. Each input gets its own buffer to stop oscillators pulling on each other, and output A can feed input B1 for a seven channel mix.

Documentation

• Assembly instructions
• Bill of materials (BOM)
• Schematic

Links

• Source / files on GitHub
• Maker page

More from Jypma

AS3340 VCO Analogue VCO with octave switch and per note fine tune PT2399 Delay PT2399 delay with feedback in 4HP Quad Attenuverter Four attenuverters with offset and polarity LEDs Ray Wilson Dual VCA Dual linear and exponential VCA SCM 140 ADSR Roland System 100 style ADSR envelope Steiner VCF Steiner Parker multimode filter with switch selected modes TH 555 VCO Thomas Henry 555 based VCO DuinoRack ATmega328 module with screen and encoders running swappable firmware

More mixer modules

Frames Mutable Instruments Mak Mak Voxmachina STMix Befaco Morphader Befaco STMix 1U Befaco EDU Mixer Erica Synths DIY Mixer Erica Synths Battle Ginko Synthese

This is a third-party open-source design, listed here as a build reference. Specs are researched from public sources; check the source repo and store for the current BOM, panel, and revision before ordering parts. Corrections welcome.

← Back to all builds Resources Suggest a correction or a missing module