1U Attenuverter

Maker	My Modular Journey
Type	1U attenuverter with 5V offset reference, buildable as a passive attenuator
Mounting	Through-hole
Width	6 HP
License	Open source (CC BY-SA 3.0, MIT or GPL-3.0 over hardware-only repos)
Difficulty	🧊 Low-count through-hole

Panel gerbers are provided in both Intellijel and Pulp Logic 1U formats. Three build configurations are documented in the guide.

Documentation

• Assembly instructions
• Schematic
• Fabrication files (PCBA-ready)

Links

• Source / files on GitHub
• Maker page

More from My Modular Journey

1U Buffered Mult 1U buffered multiple for splitting CV and audio without droop 1U LFO Small 1U low frequency oscillator for modulation duties 2HP Buffered Multiple 1 to 3 buffered multiple in 2HP Octobus Eurorack PSU and bus board fed from a wall wart transformer RingMod Transformer based active ring modulator Tuna Arduino based chromatic tuner with a 7 segment display

More utility modules

Ears Mutable Instruments Kinks Mutable Instruments Links Mutable Instruments Shades Mutable Instruments Mikrophonie Music Thing Modular Buffered Multiple diysynth Offset-Gain Utility diysynth 0HP stuff diysynth

This is a third-party open-source design, listed here as a build reference. Specs are researched from public sources; check the source repo and store for the current BOM, panel, and revision before ordering parts. Corrections welcome.

← Back to all builds Resources Suggest a correction or a missing module